ReaSnow Forum
Products => ReaSnow S1 => Topic started by: Willwas82 on September 19, 2022, 03:43:59 PM
-
I tried Bf2042 on XBox Series X/S yesterday. I felt a slight delay in the ADS. When I track the target in the ADS, it follows a bit so I'm a bit slower with the crosshairs. How can I fix this?
-
It is not slow at all for me (no delay). Adjust the ADS sensitivity to a higher result and will be perfect. Or you can try to turn on the USA (Uniform soldier aiming) but then HIP and ADS sensitivity will be the same.
-
Can you post your setting here? Would like to test them.
-
Yes i can later but it does not depend on my settings. Just adjust the ADS sens. in Reasnow App to larger result that's all. If it was about 0.45 set it to 0.50 or 0.55 or whatever.
-
If I remember correctly, I have an ADS value of 0.80 at 5000DPI. Will test again later
-
As i remember my ADS sens is much less . It is about 0.40 or 45 and my HIP sens is about 0.80 or something like that but will check it just not from the Office :D . I also use 5000 HZ on my Razer Viper 8K and 1000 HZ polling rate since the last update allows of setting 1000HZ usb report rate. (I also tried on 8000 HZ polling rate but it did not make any sense)
-
I have the ADS Min. Speed on 3 and it feels better. Also, since I had previously cleaned on the PC, I had selected the XBOX 360 controller. Now it is set to Automatic. I don't know if that was my fault, but it's better now.
-
Yes. Sometimes the best solution is to clean (restore) it on pc. In the meantime i checked my settings and .. i was wrong regarding to my HIP and ADS result because in BF2042 I had set the results prviously : HIP 1.75 ADS sens 0.80. Other options are default.