ReaSnow Forum
Products => ReaSnow S1 => Topic started by: HuLL on December 13, 2023, 06:38:07 PM
-
Good afternoon!
Today the game HUNT Showdown has received an update on PlayStation, with which a number of new control settings have been added and old settings have been changed. The current configuration does not work correctly.
Please check the configuration and make changes
-
Yes. Same on xbox
-
Can someone give me all their Ingame settings + device settings for the game on play station the new settings are a nightmare
-
We have to wait Till it is fixed.
-
Will fix the config later.
-
@JayJay@T_h_e_Guy
The config has been updated, both on PlayStation and Xbox.
-
Thx for the fast work i will Check it later! Its just downloading the config in the App, Right?!
-
@JayJay@T_h_e_Guy
The config has been updated, both on PlayStation and Xbox.
I downloaded the new configuration. It looks terrible to be honest(((( Would you mind checking it again? Maybe mistaken with the settings of the game itself for this configuration?
-
Dear Austin,
Please double check the config again, it is not working properly.
I believe for mouse movement for Aim Input Curve it should be Linear and not Exponential. Plus sensitivities are not playable.
I know you are guys busy with a lot of other staff, but now an Event is ongoing in Hunt Showdown and time is limited for it.
Please would you fix asap. Thanks in advance!
-
Yes, gunslinger and a regular or linear curve will be the Best Choice.
-
Yes, gunslinger and a regular or linear curve will be the Best Choice.
I have tried different options. nothing helps((( it works worse than before the configuration update.
-
Yes, me too, tried different settings, it is very difficult and still sticky.
-
So, i tried the following things
In Game settings as the App descripe, but i took the gunslinger.
Then in the RS Manager
Hip 26
ADS 20
Everything is off, no aimassist no aim stability
And Everything works good for me! Everything is smooth!
-
would you please provide the following details of yours,
so we can figure out the issue you are facing?
1. your console and game
2. mouse DPI/CPI and USB report rate, mouse model, and producer
3. settings in the game on console, such as sensitivity, dead zone, acceleration, aim assist, etc.
it's better to restore all settings in game and change the settings as shown in our APP, and try it again with a default game config.
4. which config has been activated in ReaSnow S1?
your settings for HIP/ADS /HIP YX Ratio/HIP MIN/ADS YX Ratio/ADS MIN/curve in this config
5. ReaSnow S1 firmware and APP version
6. a video to show us your trouble (this is very important!!!)
please upload the video to youtube or other file-sharing servers, and send us the link.
-
1. your console and game
PS5, HuntShowdown
2. mouse DPI/CPI and USB report rate, mouse model, and producer
2400 DPI, 1000 usb rate, Logitech G502
3. settings in the game on console, such as sensitivity, dead zone, acceleration, aim assist, etc.
it's better to restore all settings in game and change the settings as shown in our APP, and try it again with a default game config.
-in Game settings as the App descripe
4. which config has been activated in ReaSnow S1?
your settings for HIP/ADS /HIP YX Ratio/HIP MIN/ADS YX Ratio/ADS MIN/curve in this config
Default config for HuntShowdown. All default values. Curves have not been changed. HIP and ADS tried a range of 1 to 30.
5. ReaSnow S1 firmware and APP version
app v1.5.8, app 5.6.16
6. a video to show us your trouble (this is very important!!!)
please upload the video to youtube or other file-sharing servers, and send us the link.
I don't have the opportunity to record a video and it doesn't make sense because it's on a feeling level, not a visually obvious thing. When the mouse is moving evenly, the speed of movement on the screen is not even. There is a strange slowdown, then a strange acceleration. It's not the firmware version or my hardware. It's about the new configuration loaded, because the changes happened after that. I know about 10-15 people who faced the same problem at the same moment. They all have different hardware but the same problem. Don't you feel bad feedback from the mouse during tests?
-
So, i tried the following things
In Game settings as the App descripe, but i took the gunslinger.
Then in the RS Manager
Hip 26
ADS 20
Everything is off, no aimassist no aim stability
And Everything works good for me! Everything is smooth!
This solution has not helped me in any way.
-
https://dropmefiles.com/C3NS5
We improved the config, please give it a shot! If everything is fine, we will upload them to the server
in-game settings:
Options/Game:
Control Scheme: Hunter
Lowered
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Shoulder Aim
Shoulder Aim Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Aim Down Sights
Aim Down Sights Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Deadeye Scope = 1.0
Marksman Scope = 1.0
Sniper Scope = 1.0
Aperture = 1.0
Inner Deadzone Right = 0.20
Aim Input Curve = Exponential
Aim Boost Threshold = 90
-
https://dropmefiles.com/C3NS5
We improved the config, please give it a shot! If everything is fine, we will upload them to the server
in-game settings:
Options/Game:
Control Scheme: Hunter
Lowered
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Shoulder Aim
Shoulder Aim Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Aim Down Sights
Aim Down Sights Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Deadeye Scope = 1.0
Marksman Scope = 1.0
Sniper Scope = 1.0
Aperture = 1.0
Inner Deadzone Right = 0.20
Aim Input Curve = Exponential
Aim Boost Threshold = 90
Good afternoon!
Firstly, this configuration is definitely better than the previous one.
But there are a few disadvantages.
1.The default sensitivity when aiming from the shoulder and with the weapon lowered is very low. You have to increase sensitivity in RS manager, but the higher this value, the worse the feedback.
2.When you move the mouse with medium and high speed, everything is almost fine. But when it comes to slow movement or transition from slow to medium and back again, sometimes there are slowdowns and decreased informativeness. It was difficult for me to catch the pattern of such situations, but I partially solved this problem by changing the curve. I increased the starting value when the weapon is lowered, aiming from the shoulder and ADS. There is a slight viscosity at the start of mouse movement. Especially at low speeds.
-
I don't consider myself a programming professional, but I think the configuration should be based on a linear scheme, not an exponential one.
-
https://dropmefiles.com/q0RQX
We tested again and found that the dynamic curve is better, please try it!
in-game settings:
Options/Game:
Control Scheme: Hunter
Lowered
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Shoulder Aim
Shoulder Aim Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Aim Down Sights
Aim Down Sights Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Deadeye Scope = 1.0
Marksman Scope = 1.0
Sniper Scope = 1.0
Aperture = 1.0
Inner Deadzone Right = 0.20
Aim Input Curve = Dynamic
Aim Boost Threshold = 90
-
I don't consider myself a programming professional, but I think the configuration should be based on a linear scheme, not an exponential one.
What we need to do is to try to restore the feel of the mouse on the PC on the console, and it is not limited to these curves such as "linear" and "exponential".
Thank you for your feedback, it will make us better.
-
Strange. I can't apply the config for the Xbox layout. Imcompatible file(game console). PS4 layout is applied without errors
-
Strange. I can't apply the config for the Xbox layout. Imcompatible file(game console). PS4 layout is applied without errors
1. Which controller are you using? We export the Xbox version config with the Xbox One controller.
2. Record a video to show us your trouble
please upload the video to youtube or other file-sharing servers, and send us the URL.
-
https://dropmefiles.com/q0RQX
We tested again and found that the dynamic curve is better, please try it!
in-game settings:
Options/Game:
Control Scheme: Hunter
Lowered
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Shoulder Aim
Shoulder Aim Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Aim Down Sights
Aim Down Sights Input = Hold
Sensitivity(Horizontal) = 3.00
Sensitivity(Vertical) = 3.00
Aim Boost Strength = 0.0
Aim Boost Delay = 0.00
Aim Boost Ramp Time = 0.00
Deadeye Scope = 1.0
Marksman Scope = 1.0
Sniper Scope = 1.0
Aperture = 1.0
Inner Deadzone Right = 0.20
Aim Input Curve = Dynamic
Aim Boost Threshold = 90
Runs Perfect!
-
we have uploaded the latest update to our cloud servers,
now it can be found in our APP directly.
Thanks for your feedback!
-
we have uploaded the latest update to our cloud servers,
now it can be found in our APP directly.
Thanks for your feedback!
hi. Sir I have a problem to solve.
Each time i click the hunt module my
App Will crash.since when you upload new one module.
-
we have uploaded the latest update to our cloud servers,
now it can be found in our APP directly.
Thanks for your feedback!
hi. Sir I have a problem to solve.
Each time i click the hunt module my
App Will crash.since when you upload new one module.
I replied you on this topic: http://www.reasnow.com/forum/index.php?topic=4312.0
-
Hello Austin
Is any update available regarding Hunt showdown config?
The existing one is not playable unfortunately.
Happy new year!
-
Hello Austin
Is any update available regarding Hunt showdown config?
The existing one is not playable unfortunately.
Happy new year!
Did you use the latest config? You need to delete the config that exists and add a new one.
The in-game settings have been changed, so take a check.