ReaSnow Forum

Products => ReaSnow Cross Hair => Topic started by: herm1ne on August 30, 2018, 04:51:32 AM

Title: Can't recognize on my PC
Post by: herm1ne on August 30, 2018, 04:51:32 AM

After upgrading Cross Hair FW to the v4.0.0+, my PC no longer recognize the Cross Hair.
I followed upgrading steps and it seemed the upgrade is done without error.
There are 2 beeps and then RGB cycle... I followed all steps stated in Warning and Solution PDF.

When I use another computer to connect Cross Hair, the manager successfully recognize the Corss hair first time but after that the same thing (2 beeps and RGB cycle) happens.

When I try to reset the firmware by holding the button, it does nothing.

Would you help me out?

Title: Re: Can't recognize on my PC
Post by: richard on August 30, 2018, 03:57:13 PM

seemingly, it's caused by bad connection between cross hair and PC(cosnole).
please try another similar USB cable or buy a new one to do the connection.

or your may also try connecting cross hair to console for a comparing.
do not plug any usb devices to cross hair while doing that.

Title: Re: Can't recognize on my PC
Post by: herm1ne on August 31, 2018, 02:33:11 AM

Thanks for the reply. 
After changing the cable, the Cross Hair works like a charm.