ReaSnow Forum

Products => ReaSnow S1 => Topic started by: AlenK on February 23, 2020, 12:15:30 PM

Title: Macros stuck
Post by: AlenK on February 23, 2020, 12:15:30 PM

Hi Dev Team!

Why sometimes my macros stuck even when I properly assign all the buttons according to your “macros” manual? Especially rapid fire macro I have to press several times for it to work. The rapid fire macros work only when I overwrite it back and forth, kind of when I refresh it.

I use two dualshocks: one for connection wired to the reasnow s1 device and another via bluetooth. Maybe it is due to connectivity issues?

Title: Re: Macros stuck
Post by: AlenK on February 23, 2020, 12:17:04 PM

I use keyboard to assign macro buttons.

Title: Re: Macros stuck
Post by: AlenK on February 23, 2020, 12:53:07 PM

Macro attached.

Title: Re: Macros stuck
Post by: AlenK on February 23, 2020, 12:54:40 PM

Turn off rapid fire.

Title: Re: Macros stuck
Post by: richard on February 23, 2020, 05:22:16 PM

got it, will check and reply later.
if you can export the whole config,
it will be much helpful.

Title: Re: Macros stuck
Post by: RS1 gang on February 23, 2020, 11:32:37 PM

It’s possible get a macro for apex legend please I play on Xbox and k&m

Title: Re: Macros stuck
Post by: RS1 gang on February 23, 2020, 11:39:22 PM

This macro is good ? For apex legend all weapons..

Title: Re: Macros stuck
Post by: richard on February 24, 2020, 12:00:56 AM

but this rsl file is not a macro, it is a mouse curve file.

rsc:   config file
rsm:   macro file
rsl:     mouse curve file

Title: Re: Macros stuck
Post by: AlenK on February 26, 2020, 12:53:44 PM

Hello, Richard!

Any news on this topic? I found a temporary solution, when I rewrite timing back and forth it works, however there should be permanent solution without doing it. For e.g instead of 20ms I write 21 ms and save it and then I write back 20 ms and save it. This problem is only with the rapid fire macro.

Title: Re: Macros stuck
Post by: richard on February 27, 2020, 10:47:40 AM

if it is for rapid fire, 20ms might be too small for many games,
for no human can achieve that speed,
games might neglect that kind of clicks.

please set bigger values, such as 40ms delay for your rapid fire.
line 1: R2    40ms
line 2: ALL-NONE    40ms

Title: Re: Macros stuck
Post by: KillerTeKNiQuE on March 11, 2020, 10:41:03 AM

for rainbow six what would be the best MS for rapid fire??

Title: Re: Macros stuck
Post by: richard on March 11, 2020, 10:45:05 AM

rate of fire of every gun is different,
you need to find the best time for the gun you are using gun.

generally speaking, 20~50ms will be ok.

Title: Re: Macros stuck
Post by: KillerTeKNiQuE on March 11, 2020, 11:21:08 AM

single shot fire? or does it work with fully auto guns?

Title: Re: Macros stuck
Post by: richard on March 11, 2020, 11:38:35 AM

will work with auto guns too